|
TruSheen Surface Treatment
TruSheen Surface Treatment is
a one-time
application, permanent treatment that gives
any non porous surface a non-stick, water
repellant, impervious coating
that resists soiling, oil
contamination, discoloration and
general deterioration of the
treated surfaces.
TruSheen is Suitable for:
-
Solar Panels
-
Wind Turbines
-
Glass Surface Protection
-
Copper and Steel Pipes
-
Float, toughened and
Laminated Glass
-
Sand-Blasted and
Architectural Glass
-
Tiles, Granite and
Sandstone
-
Stainless Steel
-
Uncoated Aluminum
Instructions
STEP 1: PRE-TREATMENT
CONCENTRATE
1. Using a clean, lint-free
cloth or paper towel wipe
surface (Note: surface may feel
slightly sticky) and allow to
dry.
2. Wipe dust and dirt from
surface and clean surface with
warm soapy water for best
results.
3. In a ventilated area, add 1
part pre-cleaner with 10 parts
water into a plastic sprayer,
replace top and shake 3-5 times
(Note: This is not necessary if
Pre-Treatment is pre-mixed.)
4. Apply Pre-Treatment evenly to
surface and let set for 5-10
seconds.
5. DO NOT TOUCH pre-treated
surface (Note: please repeat
this step if surface is touched
after completing).
STEP 2: TRUSHEEN TREATMENT
1. Apply TruSheen treatment
evenly to surface.
2. Using a clean, lint-free
cloth or paper towel, lightly
buff surface steadily increase
the pressure until the entire
treated surface is visibly clear
(Note: surface will begin to
feel smooth)
3. Allow treatment to cure on
surface for 16-18 hours (Note:
cure longer for best results)
|
